Ardisam 5020D Instruções de Operação Página 16

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 15
OPERATOR INSTRUCTIONS AND PARTS
CRT Models 6015V, 6015VCE, 6015BCE
Page 16
GetEarthquake.com
800-345-6007
ENGINE MAINTENANCE
Refer to the engine manual included in your parts packet for information
on engine maintenance. Your engine manual provides detailed information

1. Check oil level before each use or after every 8 hours of operation.
2. Change oil after rst 5-8 hours of operation. Change oil while engine
is warm. Rell with new oil of recommended grade.
4. Check spark plug yearly or every 100 hours of operation.
5. Service air cleaner.
 
7. Check engine and equipment often for loose nuts and bolts, keep these
items tightened.
CHECK OR FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overll. Use a clean, high
quality detergent oil. Use no special additives with recommended oils.
Do not mix oil with gasoline. Oil level must be full. Check the oil level
by removing oil ll plug. Oil level should be up to the bottom of the ll
plug opening.
2. Always check oil level before starting engine. Refer to engine manual
for capacity and type of oil to use.
CHECK TILLER TRANSMISSION GREASE

1. Move tiller to level ground.
2. Remove grease level dipstick located between the handlebar mounts
on the engine mount. Correct grease level is indicated between the
high and low levels on the dipstick. SEE FIGURE 7
3. Replace grease level dipstick in the ller hole.
4. Note that the front wheel transmission and rear tine transmission are
one common reservoir. When you add to the front transmission, you

equalize in both front and rear. The dipstick will read correctly on level
ground for both gear units.
(Use Mystic 00, or equivalent, transmission grease)
CHECK TIRE PRESSURE
Recommended tire pressure is 20 PSI. If tires do not have equal pressure,
tiller will pull to one side.
IMPORTANT
ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL.
YOU MUST ADD ENGINE OIL BEFORE STARTING
ENGINE.
IMPORTANT
TILLER TRANSMISSION IS SHIPPED FROM FACTORY
WITH THE PROPER AMOUNT OF LIQUID GREASE.
WHEN REPLACING GREASE, THE TILLER TRANSMISSION
HOLDS 1822 OUNCES. DO NOT OVERFILL.
cover plate
transmission
gear case
dipstick
MODEL NO. 6014V
SERIAL NO.
LBL6014VSN
getearthquake.com
FIGURE 7
Vista de página 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Comentários a estes Manuais

Sem comentários