Ardisam 5020D Instruções de Operação descarregar pdf (Página 6)

OPERATOR INSTRUCTIONS AND PARTS

CRT Models 6015V, 6015VCE, 6015BCE

Page 6

GetEarthquake.com

800-345-6007

UNPACKING AND ASSEMBLY

Your rototiller comes fully assembled except for a few parts. The following

instructions will help you unpack your tiller and assemble and adjust your

tiller’s depth regulator lever, cable tension and handlebar height. You will

need 2- 9/16” wrenches.

UNPACK 6015V U.S. VERSION

1. Open top of carton and remove handlebar assembly.

 

4- 3/8-16 x 1 3/4” hex head bolts

4- 3/8-16 locknuts

1- 5/16-18 x 3/4” hex head bolt

1- detent pin

1- ve star knob

 

 

a. Putting loose wheels onto machine with lock pin disengaged from

wheel.

b. Roll tiller from carton.

UNPACK 6015VCE AND 6015BCE

EUROPEAN VERSION

1. Open top of carton and remove handlebar assembly.



4 - 3/8-16 x 1 hex head bolts

4 - 3/8-16 x 1-3/4" hex head bolts

8 - 3/8-16 locknuts

1- 5/16-18 x 3/4" hex head bolt

1- detent pin

1- 5-star knob

 

 

 

a. Putting loose wheels onto machine with lock pin disengaged from

wheel.

b. Roll tiller from carton.

ATTACH HANDLEBAR 6015V, U.S. VERSION

1. Place handlebar stems on outside of lower handlebar mount and align

lower holes. (SEE FIGURE 1A)

2. Insert one 3/8-16 x 1 3/4” bolt for each side in lower holes at the desired



3. Start 3/8-16 nuts on each bolt.

 

washers on to bolts.

5. Start 3/8-16 nuts on each bolt.

6. Tighten all 3/8-16 nuts.

CAUTION

DO NOT TRY TO LIFT THE ROTOTILLER FROM THE

CARTON.

DO NOT ADD ENGINE OIL INTO GEAR CASE DIPSTICK

HOLE.

IMPORTANT

THE RIGHT AND LEFT SIDES OF YOUR

ROTOTILLER ARE DETERMINED FROM

THE OPERATING POSITION AS YOU FACE

THE DIRECTION OF FORWARD TRAVEL.

ENGINE IS SHIPPED FROM FACTORY

WITHOUT OIL. YOU MUST ADD ENGINE

OIL BEFORE STARTING ENGINE.

TILLER TRANSMISSION IS SHIPPED FROM

FACTORY WITH THE PROPER AMOUNT OF

LIQUID GREASE.

FIGURE 1A

lower handlebar

mount

3/8" flat washers

handlebar stem

3/8-16 x 1 3/4" bolts

3/8-16 nuts

cover plate

transmission

gear case

dipstick

NO ENGINE OIL!

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentários a estes Manuais

Sem comentários

Ardisam 5020D Instruções de Operação Página 6

Comentários a estes Manuais